Adapting kickdown function |
Kick-down function adaption must be performed on vehicles with automatic gearbox if the accelerator pedal position sender or engine control unit is replaced. |
Special tools and workshop equipment required |
t
| Vehicle diagnosis and service information system -VAS 5052- |
Note t
| Engine stopped, ignition switched on |
–
| Connect up the vehicle diagnostic and service information system -VAS 5052- and select the engine electronics control unit. When doing this, the ignition must be switched on. |
–
| Select the function “Start basic setting”. |
–
| Select “Display group number 063”. |
Note You will then be given the prompt “Operate kickdown”. |
–
| Fully depress accelerator pedal beyond kickdown point and keep it pressed. |
Note During kick-down point adaption the display on the tester shows “Kick-down ADP. running”. Following successful kick-down point adaption, the display on the tester will show “Kick-down ADP. OK”. |
–
| Check the readout in display zone 4: |
|
|
|