audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing oil seal between gearbox and bevel box (on bevel box) > < Renewing flange shaft oil seal (right-side) at bevel box (outer seal)

A3 Mk2

Renewing needle bearings (polygon bearings) for flange shaft (right-side)
   
Renewing needle bearings (polygon bearings) for flange shaft (right-side)
Special tools and workshop equipment required
t  Thrust plate -VW 401-
t  Thrust plate -VW 402-
t  Press tool -VW 407-
t  Press tool -VW 412-
t  Assembly tool -VAS 3253-
t  Clamp -T10047-

Procedure
–  Remove flange shaft (right-side) → Chapter.
   
–  Fit clamp -T10047- so that markings “B” on both sections of clamp point towards each other.
l  The stepped shoulders -arrows- must then be below the bearing.
–  Screw both sections together as far as stop.
  N39-0766
–  Remove circlip -A- securing bearings.
–  Rotate shaft when pressing off -arrow- to prevent contact surface of bearings on shaft from being damaged.
  N39-0785
–  Rotate shaft when pressing on -arrow- to prevent contact surface of bearings on shaft from being damaged.
–  Secure bearings with a new circlip.
–  Install flange shaft (right-side) → Chapter.
  N39-0786

Renewing oil seal between gearbox and bevel box (on bevel box) > < Renewing flange shaft oil seal (right-side) at bevel box (outer seal)