| –
| Unscrew nut -A- at wheel bearing housing/upper link, and screw on new nut as far as stop. |
| –
| Adjust camber by turning adjuster screw -B-. Adjuster screw -B- can also be turned via hexagon flats at tip of screw. |
Note | t
| The maximum adjustment range is 135° to the left or right of the centre position. |
| t
| When the end position of the adjuster screw -B- is reached, do not turn further; otherwise components will be damaged. |
| t
| For illustration purposes the camber adjustment is shown with the wheel removed. |
| –
| Check camber value again after tightening nut -A- → Chapter. |
|
|
|
