Catera V6-3.0L VIN R (1997)
-
Clean the sensor as required.
-
Inspect for an accumulation of dirt.
-
Clean the sensor as required.
-
Inspect for an accumulation of grease.
-
Clean the sensor as required.
-
Inspect for an accumulation of other contaminants.
-
Clean the sensor as required.
-
Inspect the sensor face for evidence of damage. Inspect the sensor for contact with the toothed sensor ring. The sensor should not contact the
toothed sensor ring. Determine and correct the cause of the damage when damage is evident. Replace the sensor if damage interferes with proper
operation.
INSTALLATION PROCEDURE
Notice: The wheel speed sensor is a tight fit and is to be pushed in by hand. DO NOT force the sensor into position, as damage to the sensor could
result.
Notice: Wheel speed sensors must be given an anti corrosion coating before installation to prevent corrosion. Do not use grease. Use sealer P/N
123456739 or equivalent.
1. Install the wheel speed connector (1) to the wiring harness connector (2).
2. Install the cable (3) for the wheel speed sensor into the clips on the spring strut and the wheel housing.
3. Install the wheel speed sensor (3) into the steering knuckle (1).
4. Install the speed sensor bolt/screw (2).
-
Tighten the speed sensor bolt/screw to 8 Nm (71 inch lbs.). Refer to Fastener Notice in Service Precautions.
Notice: Proper installation of the wheel speed sensor harness is critical to continued system operation. Failure to install the harness in brackets as
shown may result in contact with moving parts, spark plug wires, and/or over extension of the wires, resulting in circuit damage.
5. Lower the vehicle.
6. Perform the Diagnostic System Check.
