| Removal and Installation Removal All Vehicles | | -
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. NOTE:Make sure the filler cap does not become contaminated. Remove the reservoir filler cap. - Disconnect the electrical connector.
- Remove the cap.
| | | -
Using a suitable suction device drain the reservoir. | Vehicles with manual transaxle | | -
Disconnect the clutch master cylinder feed hose. | All vehicles | | -
CAUTION:Cap the tube connections to prevent fluid loss or dirt contamination. Disconnect the master cylinder brake tubes. | | | -
Release the brake booster vacuum by removing the vacuum hose. | | | -
Remove the fluid reservoir and master cylinder assembly. | | | -
Remove the reservoir from the master cylinder. - Lift the two retaining clips and pull off the reservoir.
| | | -
Remove and discard the O - ring seals. | Installation | | -
Install new O - ring seals. | | | -
CAUTION:Before installing the master cylinder make sure that the vacuum seal is in place and that the mating faces are clean. To install, reverse the removal procedure. | |
