ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Hydraulic Control Unit (HCU) - 2.5L RHD > < Hydraulic Control Unit (HCU) - 2.0L RHD

Cougar 1999 (08.1998-01.2001)

Anti-Lock Control - Hydraulic Control Unit (HCU)—2.5L LHD Cougar 1999 (08/1998-01/2001)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.
  1. Remove the brake booster. For additional information, refer to Section  206-07 Power Brake Actuation.

  1. Remove the instrument panel lower panel.
    1. Remove the screw covers.
    1. Remove the screws.

  1. Detach the brake booster support brackets.

  1. Remove the brackets

  1. Disconnect the hydraulic control unit brake tubes.

  1. Disconnect the hydraulic control unit electrical connector.
    1. Release the retainer
    1. Disconnect the electrical connector.

  1. Remove the hydraulic control unit support bracket rear bolts.

  1. NOTE:
    NOTE:Observe the earth wire behind the lower bolt.
    Remove the hydraulic control unit support bracket side bolts.
    • Pull the bracket and hydraulic control unit forwards.

  1. Remove the hydraulic control unit.
    • Loosen the nuts.

Installation

NOTE:
NOTE:After installation, bleed the brake system. For additional information, refer to Section  206-00 Brake System - General Information.
  1. To install, reverse the removal procedure.

Hydraulic Control Unit (HCU) - 2.5L RHD > < Hydraulic Control Unit (HCU) - 2.0L RHD