ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Hydraulic Control Unit (HCU) - 2.0L RHD > < Anti-Lock Control

Cougar 1999 (08.1998-01.2001)

Anti-Lock Control - Hydraulic Control Unit (HCU)—2.0L LHD Cougar 1999 (08/1998-01/2001)
Removal and Installation

Removal

All Vehicles
  1. Disconnect the battery ground cable.
  1. Remove the brake booster. For additional information, refer to Section  206-07 Power Brake Actuation.

  1. Remove the air cleaner support bracket.

  1. Remove the instrument panel lower panel.
    1. Remove the screw covers.
    1. Remove the screws.

  1. Detach the brake booster support brackets.

  1. Remove the brackets.
Vehicles with air conditioning
  1. Move the air conditioning tube support bracket to the side.
All Vehicles
  1. Remove the booster side support bracket.
    1. Disconnect the clutch tube (if equipped).
    1. Remove the bolt.

  1. Remove the master cylinder fluid feed tubes.

  1. Disconnect the hydraulic control unit brake tubes.

  1. Disconnect the hydraulic control unit electrical connector.
    1. Release the retainer.
    1. Disconnect the electrical connector.

  1. Loosen the nuts.

  1. Lift the hydraulic control unit off the bracket and maneuver off the vehicle.

Installation

NOTE:
NOTE:After installation, bleed the brake system. For additional information, refer to Section  206-00 Brake System - General Information.
  1. NOTE:
    NOTE:Ensure the hydraulic control unit is correctly fitted to the locating peg.
    To install, reverse the removal procedure.

Hydraulic Control Unit (HCU) - 2.0L RHD > < Anti-Lock Control