ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Output Shaft Speed (OSS) Sensor > < Main Controls

Mondeo 2001 (10.2000-02.2007)

Automatic Transmission/Transaxle - Vehicles With: 4-Speed Automatic Transmission (CD4E) - Turbine Shaft Speed (TSS) Sensor Mondeo 2001 (10/2000-02/2007)
In-vehicle Repair

Materials
Name
Specification
Automatic transmission fluid
ESP-M2C166-H 
Petroleum jelly
SM-1C115-A 

Removal

  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Disconnect the turbine shaft speed (TSS) sensor electrical connector (colored white).

  1. Remove the TSS sensor.
    • Allow the oil to drain into a suitable container.
    • Discard the O-ring seal.

Installation
  1. NOTE:
    NOTE:Install a new TSS sensor O-ring seal.
    Install the TSS sensor.

  1. Connect the TSS sensor electrical connector (colored white).
  1. Lower vehicle.
  1. Start the engine and move the selector lever through all of the ranges, allowing sufficient time for each position to engage.
    • Engage the selector lever in the "P" (park) position.
  1. Check the transmission fluid level.
    For additional information, refer to Preliminary Inspection in this section.
  1. Add automatic transmission fluid, if necessary.

Output Shaft Speed (OSS) Sensor > < Main Controls