Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Windshield Glass >
< Rear Window Glass
Puma 1998 (06.1997-12.2001)
Mechanical Repairs
5 Body and Paint / 501 Body and Paint
501-11 Glass, Frames and Mechanisms
Description and Operation
Diagnosis and Testing
General Procedures
Removal and Installation
Front Door Window Regulator and Motor
Glass, Frames and Mechanisms - Front Door Window Regulator and Motor
Puma 1998 (06/1997-12/2001)
Removal and Installation
Removal
Remove the door trim panel. For additional information, refer to Section
501-05 Interior Trim and Ornamentation
.
CAUTION:
Do not touch the adhesive surface as re-bonding will be impaired.
Peel back the door watershield.
Connect the battery ground cable.
Connect the window switch.
NOTE:
Lower the glass, till it is a quarter up, to gain access to the glass clamp bolts.
Remove the glass calmp bolts.
CAUTION:
Make sure the glass is adequately supported at the top of the channel.
Release the glass from the regulator.
Disconnect the battery ground cable.
Drill out the two rivets from the regulator.
Disconnect the regulator motor electrical connector.
Remove the regulator and motor.
Installation
Install the regulator and motor.
Install the window regulator to the door with rivets.
Connect the regulator motor electrical connector.
Connect the battery cable.
Adjust the door glass. For additional information, refer to the General Procedures in this section.
Install the door watershield.
Install the door trim panel. For additional information, refer to Section
501-05 Interior Trim and Ornamentation
.
Mechanical Repairs
5 Body and Paint / 501 Body and Paint
501-11 Glass, Frames and Mechanisms
Description and Operation
Diagnosis and Testing
General Procedures
Removal and Installation
Front Door Window Regulator and Motor
Windshield Glass >
< Rear Window Glass