| Removal and Installation Removal WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or removing any SRS components. WARNING:Make sure that the vehicle electrical system is fully depowered and no other power source is connected. WARNING:Wear safety goggles. WARNING:Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation). | | -
Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | Information Not Found | | -
NOTE:Note the position of the component before removal. | | | -
NOTE:Note the position of each component before removal. | Installation NOTE:Make sure that a new component is installed. | | -
If the side air curtain module was deployed, check the vehicle body side air curtain mountings and ramps for deformation. | | | -
NOTE:Make sure that these components are installed to the noted removal position. Attach the side air bag module retaining clips in the following sequence. | | | -
NOTE:Make sure that this component is installed to the noted removal position. | | | -
Initialize the door window motors. Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | | 
