| Removal and Installation Special Tool(s) | | Remover / installer, coolant hose clips 303-397 (24-003) | General Equipment Removal NOTE:Removal steps in this procedure may contain installation details. Vehicles with air conditioning | | -
Drain the air conditioning system.
For additional information, refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging (412-00 Climate Control System - General Information, General Procedures).
| All vehicles | | -
Raise and support the vehicle. For further information, refer to Section 100-02 (Workshop Manual/TIS-CD).
For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation).
| | | -
Disconnect the coolant hoses. | Vehicles with air conditioning | | -
Detach the refrigerant lines at the evaporator. | All vehicles | | -
Remove the load space trim panel. | | | -
Disconnect the electrical connector. | | | -
Detach the booster heater housing from the side panel. | | | -
Disconnect the booster heater valve connector. | | | -
Detach the coolant hoses from the booster heater housing using the special tool. | | | -
Remove the booster heater housing. | Installation | | -
For installation, reverse the removal procedure. | |
