Discovery II
PANEL REPAIRS
REPAIRS 77-2-41
Refit
1. Fit side drip rail finisher.
2. Fit wiring to 'B/C' post and sill areas.
3. Fit front and rear door door aperture seal.
4. Position carpet and secure with fixings.
5. Fit tread plates to front and rear door apertures.
6. Fit head lining.
7. Fit rear seat.
8. Fit front seat belt.
9. LH side: Fit CD autochanger.
10. RH side: Fit power amplifier.
11. Fit RH or LH front seat.
12. Fit sill finisher.
13. Fit front door striker to B/C post, fit Torx bolts
and tighten to 26 Nm (19 lbf.ft).
14. Fit rear door.
15. Connect leads/multiplug to alternator.
16. Connect battery leads, negative lead last.
Panel body side assembly
Remove
1. Disconnect both battery leads, negative lead
first.
2. Disconnect leads/multiplug from alternator.
3. Remove loadspace side trim casing.
REPAIRS, Trim casing - side - loadspace.
4. Remove head lining rear trim finisher.
5. Remove rear head rests, if fitted.
6. Remove body side rear glass.
SCREENS, REPAIRS, Glass - body
7. Remove rear bumper assembly.
Bumper assembly - rear - up to 03MY.
8. Remove rear bumper finisher.
9. Remove rear wheel arch liner.
10. Remove mud flap.
11. Remove tread plate from rear door aperture.
12. Remove rear door aperture seal.
13. Remove rear door striker from 'D' post.
14. Remove 'D' post outer trim finisher.
15. Remove wheel arch trim finisher.
16. Remove side drip rail finisher.
17. RH side: Remove tail door.
18. LH side: Remove tail door striker and setting
block from 'E' post.
19. Remove tail door tread plate.
20. Remove loadspace carpet retainer.
21. Remove tail door aperture seal.
22. Remove tail lamp.
LIGHTING, REPAIRS, Lamp - tail.
23. RH side: Remove fuel filler flap.
24. RH side: Remove fuel filler tube.
25. Remove aerial amplifier.
26. Remove relevant wiring from body side area.
