Mazdaspeed6 L4-2.3L Turbo (2006)
1. Park the vehicle on level ground.
2. Remove the oil level plug and washer.
3. Verify that the oil is near the brim of the plug port.
^
If the oil level is low, add the specified amount and type of oil through the filler plug hole.
Manual transaxle oil [A26MX-R]
Specified oil grade: API Service GL-4 or GL5
Specified oil viscosity: SAE 75W-90
4. Tighten the oil level plug with a new washer.
Tightening torque 27.5 - 50.9 Nm (2.8 - 5.1 kgf-m, 37.5 - 20.2 ft. lbs.)
Transaxle Oil Replacement [A26MX-R]
TRANSAXLE OIL REPLACEMENT [A26MX-R]
A26MX-R
1. Remove the drain plug with the washer.
2. Drain the oil into a suitable container.
3. Install a new washer and the drain plug.
Tightening torque 27.5 - 50.9 Nm (2.8 - 5.1 kgf-m, 37.5 - 20.2 ft. lbs.)
4. Remove the oil level plug with washer and add the specified amount and type of oil through the oil level plug hole until the level reaches the
bottom of the oil level plug hole.
Manual transaxle oil [A26MX-R]
Specified oil grade: API Service GL-4 or GL-5
Specified oil viscosity: SAE 75W-90
Capacity (approximate quantity): 2.55 Liters (2.69 US quarts, 2.24 Imp quarts)
5. Install a new washer and the oil level plug.
Tightening torque 27.5 - 50.9 Nm (2.8 - 5.1 kgf-m, 37.5 - 20.2 ft. lbs.)
