Clutch actioning: repairing

Make

SEAT

Model

Leon Mk1

Section

085 5-speed manual gearbox › Clutch, control › Clutch actioning: repairing

Power transmissionClutch actioning: repairing

Fitting (clutch cable not tensioned) –  Pull the clutch cable through the bulkhead. –  Lubricate the clutch cable securing/clutch pedal area with -G 052 142 A2- grease.

–  Hook the clutch cable onto the clutch pedal -arrow-.

–  Pull the end of the cable in the -direction of the arrow 1- and maintain pulled. Slide the sleeve with adjustment mechanism -B- several times in the direction of the arrow -direction of the arrow 2- until it can be compressed aginst the bulkhead wall.

–  Fit the tensioning cap -A- or the retaining strap onto the two projections -arrows- of the automatic adjustment mechanism. –  Fit the bellows to the wall of the bulkhead.

Fit the clutch cable to the clutch release lever as described below: –  Fit the rubber stop -3- into its location in the gearbox casing. –  Pull the sleeve -2- in the direction of vehicle movement and fit the clutch cable into its location on the clutch release lever -1-.

–  Secure the clutch cable to its location -arrow-.   Note! On securing the clutch cable to its location do not bend, otherwise the automatic adjustment mechanism could stop working properly.

–  Remove the retaining strap or the automatic adjustment mechanism tensioning cap -arrows-. –  Checking the functioning of the clutch cable with automatic adjustment → Chapter. Once the functioning has been checked, continue assembly → Chapter, Clutch pedal: removing and fitting.

01 Transmission

The same page in: Leon Mk2.