Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Basic settings

Make
SEAT
Model
Leon Mk1
Section
7-speed dual clutch gearbox 0AM › Gearbox mechanics,operation, construction,diff. › Basic settings
Power transmissionBasic settings
Basic settings
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Central diagnosis -VAS 505X-
Procedure:
l  Central diagnosis -VAS 505X- connected.
–  Select the respective basic setting function on the Central diagnosis -VAS 505X- (in the „Guided Fault Finding“ in the directory „02 - Gearbox electronics“).
l  All instructions in the Central diagnosis -VAS 505X- must be followed for the complete execution of the basic settings.
The following „basic settings“ are available:
t  1. „Complete basic setting“
t  2. „Idle run basic setting“
t  3. „Removal position basic setting“
Description of the basic settings:
1. Complete basic setting
The „complete basic setting“ must be carried out after completing the following work:
t  When the gearbox is operated for the first time
t  after removing the dual clutch
t  when the mechatronic unit for dual clutch gearbox -J743- with control unit has been renewed.
Basic settings – SEAT Leon Mk1  Note
t  A quick and fundamental self adjustment of the gearbox is carried out using the „complete basic setting“ that is performed using the Central diagnosis -VAS 505X -. The positioning members of the clutch and gearbox are adjusted automatically again. The current drag point of the clutch, the clutch wear, the synchronisation points and the position of the positioning members of the clutch are determined and saved when engaged in a gear (end position of the positioning members of the gearbox).
t  Clutch self-adaption is performed regularly during normal driving, according to the amount of clutch wear. However, this adaption is only possible under specific driving conditions. For this reason a „Basic setting“ of the clutch must be performed after certain repairs, as listed above. This achieves optimum adjustment for gearshifts and clutch engagement when moving off.
2. Idle run basic setting
With the „idle run basic setting“, an attempt is made to switch all gears so that the vehicle can be pushed by hand (e.g. when the clutch is damaged).
  W00-10343
3. Removal position basic setting
t  With the „removal position basic setting“, the positioning members of the gearbox are placed in their removal position. This results in the mechatronic not »catching« during removal.
t  Both positioning members of clutch -A- and -B- are moved out completely in the -direction of the arrow-. The mechatronic pushes and moves both levers for operating the cutch -1- and -2-.
t  This enables a suitable screwdriver, chisel or mandrel (for securing purposes) to be inserted between both levers of the clutch operation and the gearbox casing without applying force. This is necessary for certain types of repair work.
t  Both positioning members of the clutch -A- and -B- are »loosened« when the ignition is turned off. The lever for operating the clutch -1- and -2- press the positioning member of the clutch back towards the mechatronic. Before starting up the vehicle, all »securing units« fitted must be removed.
  A34-10699

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

As an Amazon Associate we earn from qualifying purchases.