Leon Mk2
|
1 - | Brake disc |
q | Always replace by axles |
q | Unscrew brake calliper before removal. |
q | Only dress evenly, on both sides, starting from thickness when new |
q | Lubricate contact surfaces between brake disc and wheel hub with grease → replacement part catalogue. |
q | Allocation → Chapter |
q | Thickness → Chapter |
2 - | Bolt, 75 Nm |
q | M10×1.25 x 60 |
q | Always replace |
q | To do so, use socket -T40027- |
3 - | Brake back plate with guide pins and protective cover |
q | Delivered as assembled part, with sufficient grease on the guide pins |
q | If the protective covers or the guide pins are damaged, then the repair kit must be fitted. Use grease sachet supplied to lubricate the guide pins. |
4 - | Bolt, 75 Nm |
q | Always replace |
q | M10 x 1.25 x 50 |
5 - | Brake pads |
q | Always replace by axles |
q | Before installing the pads, clean pad guide surfaces and lubricate with grease → replacement part catalogue. |
q | removing and fitting → Chapter |
q | Check brake pad thickness: → Booklet301 |
q | Different versions → Parts catalogue |
6 - | Heat shield for brake disc |
7 - | Bolt, 10 Nm |
q | M6 x 12 |
8 - | Self-locking bolt, 35 Nm |
q | Always replace |
q | Counterhold guide bolt when loosing and tightening |
9 - | Housing for brake calliper |
q | Do not disconnect brake hose when changing brake pads |
q | Servicing brake callipers |
10 - | Wheel bolts |
q | Mount the wheels → Running gear, shafts, steering; Rep. gr.44 |
11 - | Torx screw |
q | Tightening torque: 5 Nm |