skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

For engine with identification characters BMD > < Intake manifold - Summary of components
For engine with identification characters AWY
   
For engine with identification characters AWY
1 - 8 Nm
2 - Throttle valve control unit -J338-
q   check → Vehicle diagnostic tester
q   when replacing the engine control unit perform adaptation → Vehicle diagnostic tester
q   6-pin plug
3 - O-ring
q   pay attention to correct installation position
q   replace
4 - from activated charcoal filter system solenoid valve 1 -N80-
5 - from vacuum regulating valve (PCV valve)
6 - Sealing ring
q   replace
7 - 20 Nm
8 - 2 Nm
9 - Intake manifold pressure sender -G71- with intake air temperature sender -G42-
q   4-pin plug
q   contacts gold-plated
10 - O-ring
q   replace if damaged
11 - 15 Nm
12 - Tensioning sleeve
13 - Insert
14 - Intake manifold support
15 - Sealing ring
q   replace
16 - Intake manifold
17 - Retaining clip
18 - Intermediate piece

   

For engine with identification characters BMD > < Intake manifold - Summary of components