| Removing and installing the cylinder head |
| Special tools and workshop equipment required |
| t
| Threaded bores -T30011/2A (3450/2A)- |
| t
| Catch pan, e.g. -VAS 6208- |
| t
| Pliers for spring strap clamps |
| t
| Sealant remover gasket stripper (bearing code GST, bearing article no. R 34402), manufacturer Retech s.r.o. |
| t
| Cleaning and degreasing agent, e.g. -D 009 401 04- |
| l
| Engine temperature should not exceed 35 °C, because the cylinder head could be twisted when slackening the screws. |
| l
| The pistons must not be in TDC. |
|
|
|
