skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Actuator rod for manual slider - replacing steel spring and screw for shift shaft > < Remove the slide valve body

Octavia Mk1

Install slide valve body
   
Install slide valve body
–  Position the slide valve body without force on the gearbox.
–  Turn the manual slider -1- with the offset side -arrow- towards the actuator rod -2-.
–  Hook the actuator rod with the lever into the manual slider, as shown in the figure.
l  Fitting position manual slider: Flat part of the manual slider -1- to the gearbox.
  N38-0187
–  Tighten the screws for the slide valve body -arrows- in 2 stages as follows:
1.  Tighten by hand.
2.  Tighten from inside to outside and crosswise to 5 Nm.
–  Move conductor foil in such a way that it is not bent or turned when installing.
–  Pull plug of conductor foil through the gearbox housing.
–  Insert cable bushing and tighten securing screw -1-.
–  Adjust actuator rod for manual slider → Chapter.
–  Install ATF strainer → Chapter.
–  Top up ATF after repair → Chapter.
Tightening torques
  A38-0042
ComponentTightening torque
Overflow tube at oil pan2 Nm
ATF screw plug at oil pan15 Nm
Slide valve body to gearbox housing (from inside to outside)5 Nm
Screw for manuel slider4 Nm
Screw for cable bushing15 Nm
Oil pan at gearbox housing (crosswise)12 Nm
Protective plate at gearbox housing45 Nm

   

Actuator rod for manual slider - replacing steel spring and screw for shift shaft > < Remove the slide valve body