Octavia Mk1
| Disassembling and assembling the ATF pump |
Note| t | Observe the repair instructions → Chapter |
| t | The gearbox identification characters are assigned to the spare parts for the ATF pump and the ATF pump itself. |
| 1 - | Piston ring |
| q | removing and installing → Fig. |
| q | check for correct position → Fig. |
| 2 - | Piston ring |
| q | removing and installing → Fig. |
| q | check for correct position → Fig. |
| 3 - | Piston ring |
| q | removing and installing → Fig. |
| q | check for correct position → Fig. |
| 4 - | Thrust washer |
| 5 - | Piston |
| q | The sealing lips are vulcanized to the pistons |
| q | for removal, lift off from the guide wheel support at several points using a screwdriver |
| q | moisten sealing lips with ATF before inserting |
| q | Fitting position: Sealing lip points towards the guide wheel support |
| q | turn piston slightly when installing |
| 6 - | 10 Nm |
| q | then torque a further 45° |
| 7 - | Guide wheel support |
| 8 - | Outer gear |
| q | Manufacturer identification -arrow- points towards the guide wheel support |
| q | if the outer gear is incorrectly installed, the ATF pump in the installed position is stiff |
| 9 - | Inner gear |
| q | Fitting location: the larger shoulder points towards the guide wheel support |
| 10 - | Housing for ATF pump |
| 11 - | O-ring |
| q | always replace → Electronic Catalogue of Original Parts |
| 12 - | Gasket ring for torque converter |
| q | removing and installing → Chapter |
|
|
