Venza FWD V6-3.5L (2GR-FE) (2010)
Wheel Fastener: Service and Repair
Rear Axle Hub Bolt
Components
AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: COMPONENTS
Replacement
AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: REPLACEMENT
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY See: Brakes and Traction Control/Parking Brake System/Service and
Repair/Disassembly
3. REMOVE REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Removal
4. REMOVE REAR AXLE HUB BOLT
(a) Temporarily install the 2 nuts to the rear axle hub bolt as shown in the illustration.
Text in Illustration
Recommended service nut:
Thread diameter: 12.0 mm (0.472 in.)
Thread pitch: 1.5 mm (0.0591 in.)
NOTICE: