|
Coolant temperature sensor, Remove and Install (X
14 XE, Z 14 XE, X 16 XEL, Z 16 XE, Z 16 YNG)
 Remove
|
Open coolant drain bolt – collect escaping coolant.
Remove engine cover.
Remove air cleaner housing – see illustration "Air Ducts X
14 XE, Z 14 XE, X 16 XEL, Z 16 XE, Z 16 YNG".
Disconnect wiring harness plug (1) from coolant temperature
sensor.
Detach coolant temperature sensor (2) from thermostat
housing.
|
|
Install
Screw coolant temperature sensor into thermostat housing –
tightening torque 14 Nm / 10 lbf. ft.
Connect wiring harness plug – ensure cable routing is
correct.
Install air cleaner housing – see illustration "Air Ducts
X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE, Z 16 YNG".
Install engine cover.
Close coolant drain bolt.
Inspect
Charge and bleed cooling system – see operation "Cooling
System, Charge and Bleed" and "Cooling System, Check for
Leaks".
|
