Replace sash window (rear door)
Remove
2. |
Detach rear door inner panelling
|
|
4. |
Detach water vapour barrier
|
|
5. |
Detach inner channel strip
• |
Pull channel strip carefully from behind beginning at the
top
|
|
|
|
6. |
Detach outer channel strip
• |
Pull channel strip carefully from behind beginning at the
top
|
|
|
|
|
7. |
Loosen lower guide rail (3)
|
8. |
Detach rear guide rail seal (1)
|
9. |
Remove rear guide rail (2)
|
|
10. |
Remove rear door sash window
|
|
|
Install
11. |
Fit sash window
• |
Wind sash window half way up
|
• |
Slide the glass pane in the lower guide
|
|
12. |
Install front door rear guide rail
|
13. |
Tighten rear lower guide rail
|
14. |
Attach outer shaft strip
|
15. |
Attach inner channel strip
|
16. |
Install water vapour barrier
Note: Damaged water
vapour barrier must be replaced
• |
Apply adhesive tape to door frame according to the shaded areas
shown.
|
• |
Cut foil to size
Note: Use removed foil
and door contours as a template
|
• |
Provide cut-outs for inside handle with bearing supports and,
if available, manual window actuation
|
• |
Affix water vapour barrier without creases
|
|
18. |
Attach rear door inner panelling
|
|