Replace carpet - complete - L67
Remove
1. |
Remove front quarter panel inner panelling - both sides
|
3. |
Remove rear seat backrest
|
4. |
Remove sill panelling - both sides
|
5. |
Detach footwell instrument panel padding left and right
• |
Unscrew 2x screws on driver's side and remove footwell
panelling from bracket
|
• |
Unscrew 2x screws on passenger's side and remove footwell
panelling from bracket
|
|
|
|
7. |
Remove airbag control unit
• |
Unscrew 3x nuts (1) and remove control unit
|
• |
Release 2x wiring harness plugs and disconnect
|
|
|
|
8. |
Remove bracket from diagnostics plug (1)
|
|
|
|
9. |
Loosen cable duct (1)
• |
Disconnect 2x wiring harness plugs (2)
|
|
|
|
10. |
Remove instrument panel padding bracket - both sides
|
|
11. |
Loosen shifter rod in the engine compartment
Note: Mark installation
position.
|
12. |
Remove cage
• |
Unscrew 4x screws and remove cage with shifter rod
|
|
|
|
|
13. |
Remove carpet (2) beginning from rear
|
|
Install
14. |
Lay carpet beginning at the front
|
15. |
Install cage
• |
Insert selector cage with sliding selector shaft
|
|
16. |
Attach shifter rod in the engine compartment
Note: Pay attention to
marks
|
17. |
Install instrument panel padding bracket - both sides
|
18. |
Install cable duct
• |
Connect 2x wiring harness plugs
|
|
19. |
Install bracket for diagnostics plug
|
20. |
Install airbag control unit
• |
Connect 2x wiring harness plugs
|
|
21. |
Install centre console
|
22. |
Attach footwell instrument panel padding left and right
• |
Tighten footwell panelling in bracket and screw in 2x screws on
driver's side
|
• |
Insert footwell panelling in bracket and tighten 2x screws on
driver's side
|
|
23. |
Install sill panelling - both sides
|
24. |
Install rear seat backrest
|
26. |
Install rear quarter panel inner panelling - both sides
|
|