Volkswagen Workshop Service and Repair Manuals > Polo Mk4 > Engine | 4 - Cyl. injection engine (4-valve, rolling rockers) | Enginecrankshaft group, pistons | Crank shaft rear flange - remove and install | Crank shaft rear flange, driving wheel side - replace | D-Press rotor with Assembly tool T10017 onto crank shaft flange

D-Press rotor with Assembly toolT10017 onto crank shaft flange

D-Press rotor with Assembly tool -T10017- onto crank shaft flange

–	Tighten six-sided nut of assembly device with dynamometer key V.A.G 1331 and with opened annular key V.A.G 1332/11. Tightening torque: 35 Nm

Note

After tightening six-sided nut at 35 Nm, a small interval must remain between engine block and flange.