- Running gear
- Body
- Engine
- 4-cylinder injection engine
- 4 - Cyl. injection engine (4-valve, rolling rockers)
- Technical data
- Engine assy,cylinder block,crankcase
- Enginecrankshaft group, pistons
- Engine - disassemble and assemble
- Crank shaft rear flange - remove and install
- Crank shaft seal pulley side - replace
- Crank shaft rear flange, driving wheel side - replace
- Extract flange with rotor
- Operation sequence
- Introduce flange under pressure with rotor
- A-Install flange with rotor on Assembly tool T10017
- B-Install Assembly tool T10017 with flange on the crank shaft
- Operation sequence
- C-Thread Assembly tool T10017 to crank shaft flange
- D-Press rotor with Assembly tool T10017 onto crank shaft flange
- E-Check assembly position of crank shaft rotor
- F- retighten driving wheel
- Crank shaft - remove and install
- Piston and rod - remove and install
- Engine cylinder head, valve gear
- Engine lubrication
- Engine cooling
- Fuel supply, gas operation
- Mixture preparation system, electronic inj.,Gas
- Exhaust system
- Ignition system, glow plug system
- 4 - Cyl. diesel engine (with distributor injection pump)
- 4 - Cyl. diesel engine (with unit injectors)
- 4 - Cyl. injection engine
- Vehicle electrics
- Power transmission
- Heating, ventilation, air conditioning
- Clutch and gearbox