Running gearTest prerequisites
| l
| Check suspension, wheel bearing, steering and steering linkage for excessive play and damage. |
| l
| Tread depth difference of no more than 2 mm on one axle. |
| l
| Tyres inflated to correct pressures. |
| l
| Fuel tank must be full. |
| l
| Spare wheel and vehicle tools are stowed in correct locations. |
| l
| Windscreen washer fluid reservoir must be full. |
| l
| When checking wheel alignment, ensure that sliding plates and turntables are not touching end stop. |
| l
| The test equipment must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions. |
| If necessary, contact the manufacturer for familiarisation with the proper use of the wheel alignment unit. |
| Wheel alignment platforms and wheel alignment units and computers can lose their calibration over a period of time. |
| Wheel alignment platforms and alignment units/computers should be checked and adjusted as necessary during inspection and maintenance at least once per year! |
| –
| Treat these highly sensitive units carefully and conscientiously! |
|
|
|
01 Steering & suspension
