V70 GL L5-2.4L VIN 55 B5254S (1998)
5. Install pump:
a. Place protective paper over generator (pump may still contain fluid).
b. Install mounting bolts (five). Tighten to 25 Nm (18 ft. lbs.).
c. Install guard plate bolt and spacer sleeve. Tighten to 25 Nm (18 ft. lbs.).
d. Tighten guard plate lower mounting to 25 Nm (18 ft. lbs.).
6. Install/reconnect:
a. Return and pressure hoses. Fit new O-ring on pressure hose.
b. Clip securing hoses to dipstick tube.
c. Coolant hose.
7. Install:
a. Pump drive belt.
b. Cooling-air hose to control module box.
8. Top up with coolant.
9. Fill power steering reservoir with fluid and bleed system.
a. Turn steering wheel repeatedly from lock to lock and top up fluid as required.
b. Lower car.
c. Apply parking brake and start engine.
d. Check fluid level while bleeding system as described below.
-
A. Turn steering wheel slowly to right and hold in limit position for 10 seconds.
-
B. Turn steering wheel slowly to left and hold in limit position for 10 seconds.
e. Repeated steps A and B 20 times. Move car after 10 times to avoid damage to tires.
Disassemble
Tool Required
^
999 5443 Puller
^
999 5444 Press Tool
^
999 5515 Drift
