NSX V6-3.2L DOHC (2001)
NOTE:
-
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
-
Mask off surrounding surfaces before applying primer.
2. Clean the body bonding surface with a sponge dampened in alcohol.
NOTE: After cleaning, keep oil, grease or water from getting on the surface.
3. Install the rear defogger sub-harness and ground cable/antenna lead in the upper molding.
4. Set the rear window upright on the body, then center it in the opening. Make alignment marks across the rear window and body with a grease
pencil at the four points shown.
5. With a sponge, apply a light coat of glass primer around the edge of the rear window as shown, then lightly wipe it off with gauze or cheesecloth.