RDX L4-2.3L Turbo (2008)
-
Assemble the washer, collar and bushing on the upper anchor bolt as shown.
-
If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner is properly plugged in.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft codes for the audio system and the navigation system (if equipped).
-
Set the clock (on vehicle without navigation).
-
Check for any DTCs that may have been set during repairs, and clear them.
Front Seat Belt Buckle
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. Lift up the front seat, then detach the seat belt switch connector (A) and seat belt buckle tensioner connector (B), detach the harness clip (C), and
release the harness band (D).
5. Remove the center anchor bolt (A), then remove the seat belt buckle (B) from the elastic band (C).
