RDX AWD L4-2.3L Turbo (2010)
Axle Shaft Assembly: Removal and Replacement
Rear Driveshaft Removal
Rear Driveshaft Removal
Special Tools Required
-
Driveshaft Remover 07AAD-S3VA000
NOTE: Be careful not to damage the brake hose, sensor, and harness.
1. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the rear wheels.
3. Pry up the stake (A) on the spindle nut (B), then remove the nut.
4. Remove lower arm A.
5. Remove the flange bolt (A) and separate the knuckle from lower arm B.