RL V6-3.5L (2007)
1. Insert the bottom of the trim into the dashboard (B).
2. Place the trim over the A-pillar (C), and fit its upper clip (D) and the other clips (E) into holes (F) in the A-pillar, then lightly push the trim into
place.
NOTE:
-
Make sure the side curtain airbag isn't tucked down under the clips and ribs.
-
Push lightly on the upper clip. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
12. Reinstall the front door opening trim.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
B-Pillar Lower Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
-
Front door sill trim
-
Rear door sill trim
-
Front door opening trim, as needed
-
Rear door opening trim, as needed
2. Slide the front seal forward fully.
