RSX L4-2.0L (2005)
Trim Panel: Service and Repair
Trim Removal/Installation - Rear Side Area
Trim Removal/Installation - Rear Side Area
Special Tools Required
KTC trim tool set SOJATP2014
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove these items, and remove the trim as shown:
-
Rear seat-back and seat cushion
-
Rear seat-back pivot bracket
-
Door sill trim
2. Install the trim in the reverse order of removal, and note these items:
-
Replace any damaged or stress-whitened clips.
-
Make sure the connectors are plugged in properly.
-
When installing the rear side trim panel, make sure there are no pinches in the belt.
-
Apply liquid thread lock to the rear seat-back pivot bolt before installation.
-
Push the clips into place securely.