TL V6-3.5L (2007)
6. With the vehicle on the ground, remove the strut brace (A).
7. Remove the reservoir cap and brake fluid from the master cylinder reservoir.
8. Disconnect the brake fluid level switch connector (A).
9. Disconnect the brake lines (B) from the master cylinder (C). To prevent spills, cover the hose joints with rags or shop towels.
NOTE: Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
10. Remove the master cylinder mounting nuts (D) and washers.
11. Remove the master cylinder from the brake booster (E). Be careful not to bend or damage the brake lines when removing the master cylinder.
12. Remove the rod seal (F) from the master cylinder.
13. Install the master cylinder in the reverse order of removal, and note these items:
