TL FWD V6-3.5L (2009)
-
Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
-
Be sure to install the harness so that it is not pinched or interfering with other parts.
1. Place the side airbag (A) on the seat-back frame. Install the two new side airbag mounting nuts (B).
2. Install the reinforcing cloth rear hooks (C) in the seat-back frame (D).
3. Install the seat-back cover/pad. See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat-Back Cover Replacement
4. Install the clips (A) and harness holder (B) of side airbag harness to seat frame.
5. Install the seat assembly. See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation
6. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
7. Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other
parts.
8. Clear any DTCs. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
9. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select
the ON mode; the SRS indicator should come on for about 6 seconds and then go off.