TL FWD V6-3.5L (2009)
-
Assemble the washers and the collar on the center anchor bolt as shown.
-
Before installing the center anchor bolt, make sure there are no twists or kinks in the front seat belt.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Make sure the seat belt buckle switch connector is plugged in properly.
-
Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
-
Check for any DTCs that may have been set during repairs, and clear them.
Center anchor bolt installation