TL FWD V6-3.5L (2009)
3. Remove the rear seat-back. See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation
4. Pull the center seat belt out through the slit in the seat belt guide.
5. Remove these items:
-
C-pillar trim, both sides See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Interior Trim Removal/Installation -
C-Pillar Trim
-
Rear shelf See: Body and Frame/Interior Moulding / Trim/Rear Shelf/Service and Repair
6. Remove the upper anchor bolt (A).
7. Loosen the retractor mounting bolt (A), and remove the retractor bolt (B), then remove the center seat belt (C) and the retractor (D).
8. Install the seat belt and buckles in the reverse order of removal, and note these items:
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions as described. See: Testing and Inspection
-
Assemble the washer on the center anchor bolt as shown.
-
Before installing the center anchor bolt, make sure there are no twists or kinks in the center seat belt.
Center anchor bolt installation
