ZDX V6-3.7L (2010)
1. Start at the bottom edge of the door panel, detach the clips (B) with a commercially available trim pad remover.
2. Detach the remaining clips (C).
3. Starting at the rear, pull the door panel upward.
NOTE: The inner handle cable (D) and the latch cable (E) are connected to the inner handle (F). Do not pull up the door panel too far, or the cables will
be damaged.
8. While holding the door panel away from the door, release the hook (A) and the pin (B) by pulling out the inner handle (C), then remove the inner
handle from the door panel.
9. While holding the door panel (A) away from the door, disconnect the power window switch connector (B) and the power mirror switch connector
(C) (driver's door).
NOTE: If you are only removing the door panel, go to step 21. If you are doing further disassembly of the door panel, continue to step 10.
