ZDX V6-3.7L (2010)
NOTE: Be careful not to damage the tweeter connector when removing the A-pillar trim.
5. If the side curtain airbag has been deployed, replace the A-pillar trim with a new one See: Restraint Systems/Air Bag Systems/Service and Repair.
6. If the side curtain airbag has not deployed, check the A-pillar trim (A) and note the following items:
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect the A-pillar trim and replace it with a new
one if it has any of the following damage:
-
Any cracks, deformations, or stress-whitened areas in the A-pillar trim
-
Any cracks or stress-whitening in the clip seating surfaces (B)
-
Replace the upper clip (C) with a new one after check the overlap.
-
If the clip (D) is damaged or stress-whitened, replace it with a new one.
7. Temporarily install the A-pillar trim (without the upper clip) to check the overlap between the trim and the headliner See: Restraint Systems/Air
Bag Systems/Service and Repair. Remove the trim, and if necessary, adjust the overlap.
8. Carefully install the new upper clip (A) to the A-pillar trim (B). Be sure that the grommet (C) is nearest to the top of the pin (D) as shown.