ZDX V6-3.7L (2010)
Trim Panel: Service and Repair
Interior Trim Removal/Installation - Cargo Area
Interior Trim Removal/Installation - Cargo Area
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
Floor lid
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the front floor lid (A).
2. Open the rear floor lid (A). Pry out the clips (B) on both ends of the rear floor lid support struts (C), and then remove the support struts from the
pivot bolts (D). Do not remove the clips from the struts.
NOTE: Use eye protection when doing this procedure.
3. Close the rear floor lid (A). Remove the screws, then remove the rear floor lid.
