ZDX V6-3.7L (2010)
4. If necessary, remove the tool box spacer (A).
5. Install the floor lid in the reverse order of removal.
Rear trim panel
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the tailgate weatherstrip near the rear trim panel, as needed See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Weatherstrip/Service and Repair.
2. Remove the rear trim panel (A).
1. Open the rear floor lid.
2. Pry out the covers (B) and remove the screws, then remove the tie down hooks (C).
3. Release the hooks (D) and the tabs (E) from the rear side trim panels.
4. Pull up the rear trim panel by hand to detach the clips.