ZDX V6-3.7L (2010)
4. Connect the stabilizer link (A) to the damper (B), and loosely install a new flange nut (C).
5. Tighten the flange nut to the specified torque, while holding the joint pin (D) with the hex wrench (E)
6. Tighten the flange nuts on top of the damper to the specified torque.
7. Tighten the damper pinch bolts while holding the flange nuts to the specified torque.
8. Install the service caps.
9. Install the wheel speed sensor harness (A) and the brake hose (B) to the damper (C).
