ZDX V6-3.7L (2010)
10. With active damper system: Connect the damper 2P coil connector (A), and install the flange bolt (B), and attach the harness clip (C).
NOTE: Be careful not to damage or contaminate the connector.
11. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheel.
12. With active damper system: Start the engine, then make sure there are no active damper system DTCs with the HDS See: Suspension Control (
Automatic - Electronic )/Testing and Inspection/Initial Inspection and Diagnostic Overview.
13. With active damper system: Do the DAMPER FORCE OPERATION TEST in the FUNCTIONAL TESTS MENU with the HDS, then make sure
all four damper units function normally.
14. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.