ZDX V6-3.7L (2010)
2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the inboard boot.
NOTE: Do not reuse the removed right front driveshaft inboard boot.
3. Install the spider (A) onto the driveshaft by aligning the marks (B) you made on the spider and the end of the driveshaft.
4. Install the snap ring (C) into the driveshaft groove.
5. Fit the rollers (A) onto the spider (B) as shown, and note these items:
-
Reinstall the rollers in their original positions on the spider by aligning the marks (C) you made.
-
Hold the driveshaft pointed up to prevent the rollers from falling off.
