ZDX V6-3.7L (2010)
9. Adjust the length (A) of the driveshafts to the figure as shown, then adjust the boots to halfway between full compression and full extension. Bleed
excess air from the boots by inserting a flat-tipped screwdriver between the boot and the joint.
10. Install new boot bands.
NOTE: Right side is only the low profile type.
-
For the double loop type, go to step 11.
-
For the low profile type, go to step 20.
11. Fit the boot ends onto the driveshaft and the inboard joint, then install a new double loop band (A) onto the boot (B).
NOTE: Pass the end of the double loop band through the clip (C) twice in the direction of the forward rotation of the driveshaft.