ZDX V6-3.7L (2010)
8. Remove the inboard boot. Be careful not to damage the boot.
9. Remove the vinyl tape.
Outboard Joint Side
1. Remove the boot bands. Be careful not to damage the boot.
-
For the ear clamp type See: Front Driveshaft Disassembly.
-
For the low profile type See: Front Driveshaft Disassembly.
2. Slide the outboard boot (A) partially toward the inboard joint side. Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same level as the outboard joint end (C).
5. Securely clamp the driveshaft in a bench vise with a shop towel wrapped around the driveshaft.
6. Remove the outboard joint (A) using the 24 x 1.5 mm threaded adapter (B) and a commercially available 5/8''-18 UNF slide hammer (C).
