09 · Transmission

Hose from damper - r r

Make: Alfa Romeo
Model: GT Factory Service Manual
Year: 2003–2010
Section: Clutch release controls › Hose from damper - r r

‹ Prev Hose from clutch reservoir to master cylinder (pump) - r + r Next › Clutch hydraulic circuit vibration damper - r+r

ClutchHose from damper - r r

HOSE FROM DAMPER - R R

Operation 1820B54 · HYDRAULIC CLUTCH SYSTEM

3.2 V6

Removing

Proceed with removal

Op. 5530B10 BATTERY - R+R

Proceed with removal

Remove the protective cap on the master cylinder bleed valve.

Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.

Connect the collection system (pipe and reservoir) to the bleed valve on the clutch operating cylinder.

Operate the clutch pedal until the brake-clutch fluid reservoir is empty.

1. Undo the connector (1a) and disconnect the pipe from the vibration damper to the operating cylinder (1b), operating cylinder side.

2. Remove the split pin (2a) and disconnect the pipe from the vibration damper to the operating cylinder (2b), vibration damper side.

3. Remove the pipe from the vibration damper to the operating cylinder (3a) after having released it from the band (3b).

Refitting

1. Place the pipe from the vibration damper to the operating cylinder (1a) back in its housing and secure it to the band (1b).

2. Connect the pipe from the vibration damper to the operating cylinder (2a), vibration damper side and secure it using the split pin (2b).

3. Connect the pipe from the vibration damper to the operating cylinder (3a), operating cylinder side and tighten the connector (3b) to the recommended torque.

	Fastening	Component	Ø	Value (daNm)
3b

Fastening

Component

Value

(daNm)

Bleed the air and top up the level in the hydraulic clutch system

Op. 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR.

Bleed the air from the hydraulic braking system

Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR.

Proceed with refitting

Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..

Proceed with refitting

Op. 5530B10 BATTERY - R+R.

1.9 JTD 16V

Removing

Proceed with removal

- 1016A10 sound-proofing cover - r + r

Proceed with removal

Op. 5530B10 BATTERY - R+R

Remove the protective cap on the master cylinder bleed valve.

Connect the collection system (pipe and reservoir) to the bleed valve on the clutch operating cylinder.

Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.

Loosen the bleed valve.

Operate the clutch pedal until the brake-clutch fluid reservoir is empty.

1. Undo the connector (1a) and disconnect the pipe from the vibration damper to the operating cylinder (1b), operating cylinder side.

2. Remove the split pin (2a) and disconnect the pipe from the vibration damper to the operating cylinder (2b), vibration damper side.

3. Remove the pipe from the vibration damper to the operating cylinder (3a) after having released it from the band (3b).

Refitting

1. Place the pipe from the vibration damper to the operating cylinder (1a) back in its housing and secure it to the band (1b).

2. Connect the pipe from the vibration damper to the operating cylinder (2a), vibration damper side and secure it using the split pin (2b).

3. Connect the pipe from the vibration damper to the operating cylinder (3a), operating cylinder side and tighten the connector (3b) to the recommended torque.