Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Alfa Romeo GT Factory Service Manual (2003-2010)22 · Fault diagnosis
22 · Diagnostics

Seats creaking

Make
Alfa Romeo
Model
GT Factory Service Manual
Year
2003–2010
Section
Noisy'' / vibrations › Seats creaking
Fault diagnosisSeats creaking

SEATS CREAKING

When the car is moving, especially on rough ground or during acceleration or braking, there is noise from one of the front doors

Results of the tests
1CHECKING GUARD AND CONTROL FASTENINGSAll OKProblems metOperation

Check that the following are fixed correctly:

  • Of guards;

Of seat belt anchorage.

Simulate movement that takes place during cornering to check for fouling within seat lift device

Continue to Step 2External guard fastenings faulty

Refasten correctly, and refit felt pads if necessary Op.

Op. 7045A43 SEAT EXTERIOR GUARD - R R

Internal guard fastenings faulty

Refasten correctly, and refit felt pads if necessary Op.

Op. 7045A44 SEAT INTERIOR GUARD - R R

Seat belt fastening fault

Restore the correct fixing Op.

Op. 7065A12 FRONT SEAT BELT (ONE), LH OR RH, WITH PRETENSIONER ON WHEEL - R R

Noise noted during simulationEliminate the interference on the seat lift links
2CHECK ON SEAT SLIDE DEVICEAll OKProblems metOperation

Check the seat runners are properly fastened

  • To the car floor pan

To the actual seat.

Also check the guide release bow is sliding efficiently

Check the bow engagement notches

Continue to Step 3Device fastening faultyReattach the seat runners correctly
Sliding unevenReplace the guides Op. 7045A23
Bow deformationReplace the deformed bow
Engagement notches wornReplace the guides Op. 7045A23
3SEAT HEIGHT ADJUSTMENT DEVICE CHECK (driver''s side only)All OKProblems metOperation

Check the seat lift device. In particular, check that the clearance is not excessive

Also try to simulate movement during cornering to ensure no fouling is present.

The seat will lift only it someone is sitting in it

Continue to Step 4Excessive play

Replace the seat lift device and fastenings Op.

Op. 7045A36 DRIVERS SEAT MANUAL HEIGHT ADJUSTMENT DEVICE - R R

FoulingAdjust gap between fouling parts
4CHECK LUMBAR ADJUSTMENT DEVICEAll OKProblems metOperation
Check the lumbar adjustment device In particular, check that the clearance is not excessiveContinue to Step 5Excessive playChange the lumbar adjustment device Op. 7045A39
5CHECK SEAT SLIDE RELEASE LEVERAll OKProblems metOperation

Check the release lever for longitudinal adjustment of the seat.

In particular, check that the clearance is not excessive

Continue to Step 6Excessive play

Replace the release lever Op.

Op. 7045A29 SEAT SLIDE CONTROL LEVER - R R

6CHECK FOR FOULING BENEATH GUIDESAll OKProblems metOperation

Remove seat Op.

Op. 7045A10 L/H OR R/H FRONT SEAT (ONE) - R+R

and check for fouling against carpet or sound-proofing beneath the guides

Continue to Step 7Fouling present

Remove the fouling and refit the seat correctly Op.

Op. 7045A10 L/H OR R/H FRONT SEAT (ONE) - R+R

7LUMBAR ADJUSTMENT DEVICE CHECK (driver''s side only)All OKProblems metOperation

Remove part of seat upholstery Op. 7045D31

Check:

  • the attachment of the Pullmaflex plate to the frame;
  • the attachment of the regulator cables to the frame;
  • regulation casing seal.
Continue to Step 8Connections incorrectConnect affected parts correctly
Rivetting incorrectReplace instable rivets
8CHECK CUSHION AND SQUAB FASTENINGSAll OKProblems metOperation

Completely remove seat upholstery Op. 7045D11

Check that the following are fixed correctly:

  • cushion module to sub-base
  • squab beneath cushion sub-base
Continue to Step 9Bolts loosenedRestore the correct fixing
9CHECK ON CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisThe fault persists

Replace the seat Op.

Op. 7045A10 L/H OR R/H FRONT SEAT (ONE) - R+R

Parts & tools for this job For 2003 Alfa Romeo GT

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.