RADIATORE RAFFREDDAMENTO LIQUIDO SERVOSTERZO - S.R.

Operation 4130B98 · POWER STEERING HYDRAULIC SYTEM

3.2 V6

Removing

Position the vehicle on the ramp

Proceed with removal

Op. 7055B54 UNDER-ENGINE GUARD - R R

Proceed with removal

Proceed with removal

Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

Proceed with removal

Remove the power steering fluid cooling radiator air duct from its seating.

Op. 7055B42 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

1. Disconnect the rapid connectors for the inlet and outlet pipes from the power assisted steering fluid cooling radiator.

2. Undo the nuts (2a) and remove the power steering fluid cooling radiator (2b).

Op. 7210E10 R.R. FRONT BUMPER

Collect the power assisted steering fluid that comes out in a suitable container.

Refitting

Place the power assisted steering coolant radiator in its housing and secure it using the nuts.

Connect the rapid connectors for the inlet and outlet pipes to the power assisted steering fluid radiator.

Refit the power steering fluidl cooling radiator duct in its seating.

Proceed with refitting

Op. 7210E10 R.R. FRONT BUMPER.

Proceed with refitting

Op. 7055B42 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R.

Proceed with refitting

Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R.

Proceed with refitting

Op. 7055B54 UNDER-ENGINE GUARD - R R.

Fill the power steering circuit with the recommended fluid.

The table shows the total quantity of fluid present in the power assisted steering circuit.

Bleed the power steering system as described below

With the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.

Check and, if necessary, top up the fluid level in the reservoir.

Remove the car from the ramps.

Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).

Top up the fluid level in the reservoir.