Tests

Make

Audi

Model

A1

Section

Brakes, hydraulics, regulator, servo › High-pressure and low-pressure tests › Tests

Running gearTests

Tests Special tools and workshop equipment required

t  Tester for brake pressure regulator -V.A.G 1310A-

t  Brake pedal actuator -V.A.G 1869/2- High-pressure test:   Note Make sure that the brake system (master cylinder, brake hoses, brake lines and brake calipers) works properly and is free of leaks. –  Screw out bleeder screw at one of the front brake calipers. Connect tester for brake pressure regulator -V.A.G 1310 A- and bleed. –  Insert brake pedal actuator -V.A.G 1869/2- between brake pedal and driver's seat. Apply pressure to brake pedal until the gauge indicates a pressure of 50 bar. The pressure must not drop by more than 4 bar during the test period of 45 seconds. Renew brake master cylinder if drop in pressure exceeds the specification. Low-pressure test: –  Move the brake pedal actuator back until the pressure gauge indicates a pressure of 6 bar. –  The pressure should not drop by more than 1 bar within the test period of 3 minutes. Renew brake master cylinder if drop in pressure exceeds the specification.

01 Steering & suspension